A square pneumatic valve actuator mounting base that satisfies German DIN requirements is referred to as a DIN Valve Square Base.
An electromechanical valve called a DIN solenoid valve is frequently used in industrial settings to regulate the flow of gases or liquids. The German Institute for Standardization, or DIN, is the organization that establishes standards for a variety of goods and procedures.
There are two kinds of solenoid valves: single type and three-dimensional type. The installation requirements of the two types of solenoid valves are basically the same, and the installation should be carried out according to the following procedures.
According to the wiring method, there are two commonly used solenoid valve wiring methods: lead wire type and junction box type. The principle is the same. The lead type is actually to unplug the junction box and connect a power line from the coil to form an integrated type.
Solenoid valve is an industrial equipment controlled by electromagnetic, which is used to control the automatic basic components of fluid.
Valve base introduction and function. The valve base is a detachable face part in the valve, which is used to support the fully closed position of the spool and constitute a sealing pair. General valve seat diameter is the maximum flow diameter of the valve. For example, butterfly valve seat material is very wide, all kinds of rubber, plastic, metal materials can be used as seat material, such as: EPDM, NBR, NR, PTFE, PEEK, PFA, SS315, STELLITE and so on.
